Rat aortic smooth muscle cells|BNCC338097 |BNCC

Essential Information Certificate Related Products

Rat aortic smooth muscle cells

Culture medium	DMEM-H complete medium: 90% DMEM-H + 10% FBS
Subculture procedure	Recovery steps: ① Take out the frozen vial from liquid nitrogen or -80 ℃ and put it into PE gloves, quickly subtract into a water bath pot at 37 ℃, shake the frozen vial to accelerate dissolution, and completely dissolve within 1 minute. (2) Add the dissolved cell solution into a centrifuge tube containing 9ml of complete culture medium in an ultra-clean table, centrifuge at 1000-1200rpm for 5min, discard the supernatant, resuspend the cells with 1-2ml of complete media. ③The cell suspension was then added to the T25 flask containing 5-6mL of complete medium and placed in an incubator for culture. Cell subculturing: ① remove the medium, rinse twice with PBS, and add 1-2mL pancreatin (0.25% Trypsin + 0.02% EDTA); (2) Observe the digestion situation under the microscope. When the cell edge shrinks and the adherent is loose (a pasteur pipette can be used to suck out a little pancreatin and gently blow somewhere in the cell layer, the cell layer can be seen to detach with naked eyes, that is, digestion is completed, otherwise digestion is continued), directly suck out pancreatin add 5-6ml of complete medium, gently blow the cell layer off. ③ Dispense the cell suspension into a fresh T25 flask as the ratio of 1:2, add appropriate complete culture medium, mix the cell suspension evenly, and culture in an incubator. ④ Pay attention to the change of pH of medium and cell density, renew the medium regularly (2-3 times a week), and repeat the subculture or cryopreservation when the cell density reaches 80%-90%.
Growth conditions	Culture temperature 37 ℃; Atmosphere 5% CO2 + 95% air;
Growth characteristics	Adherence
Storage conditions	Liquid nitrogen
Safety level	1
morphology	Fibroblast-like, spindle-shaped
Separation substrate	Rat aorta
application	Smooth muscle cells (SMC) are the main factors leading to the development of arterial disease [1]. The ability of vascular SMC to transform into proliferative phenotype is one of the main factors in the occurrence and development of vascular diseases. Recent studies have shown that SMC expresses calcium channels [2], ICAM-1 and VCAM-1. The expression of ICAM-1 and VCAM-1 on SMC may contribute to the inflammatory response of the vascular wall and may be actively involved in the progression of vascular diseases [3]. Vascular SMC in culture plays an important role in vascular disease research and can be used to identify fresh therapeutic targets for the treatment of arterial disease.
Sharing mode	Public welfare sharing

1. Name:RASMC

2. No.: 338097

3. Growth properties : ■ adherence to the wall ；□ suspension；□ semi-suspension and semi-adherence ;

4. Growth conditions:

culture medium	90% High sugar DMEM
serum	10% FBS
temperature	37 ℃
air condition	5% CO₂,95% AIR
growth algebra	P4-5
frozen storage conditions	culture medium 50%, serum 40%, DMSO 10%

5. Composition:

composition	specifications
a bottle of cells	T25
cell culture and operation instructions	1 copy

Receiving notice:

1 Upon arrival, it is suggested to sit the cells in a incubator for about 4 hours, and then renew the media for recovery or subculture according to the cell density.
2 If the adherent cells are received in the form of ( partial) suspension, please centrifuge the suspended cells in time, add 15% serum complete medium to a fresh culture dish / vial and continue to culture for 3 days; At the same time, the remaining adherent cells in the original culture flask were renewed with 15% serum complete medium and cultured for 2-3 days. If the cells do not proliferate after 3 days but continue to detach and die, please contact the technicians.
3 Slow growth of adherent cells: properly increase the serum concentration (no more than 20%) or transfer to a fresh culture flask for further culture after trypsin digestion according to the cell density.
4 Uneven growth: if adherent cells grow unevenly and is island-like, they can be digested, dispersed, and cultured with fresh medium.

Recovery and subculture procedure ( under strict aseptic conditions )

1 Remove the medium in the original culture flask, rinse twice with PBS, and add 2~3 ml of 0.25% EDTA for trypsin digestion (usually in 1~2min)
2 Observe the digestion under the microscope. When the cell edge shrinks and adherent is loose (but not floating), remove the trypsin, add 6~8ml complete medium, aspirate the cell layer off.
3 Transfer part of the cell suspension to a fresh culture vessel / flask, add appropriate complete medium, and culture it in the incubator.
4 Pay attention to the change of pH value of medium and cell density, renew the medium regularly, and repeat the subculture or cryopreservation when the cell density reaches 70%-80%.

Special attention: (if handle in public laboratory or first time to culture the cells, it is recommended to add penicillin streptomycin into the media)
1 Upon the receipt of the cells, renew the solution with fresh 10% FBS medium as soon as possible. It is not recommended to use the medium used for transportation in the original bottle.
2 Please take photos and contact the technicians in time if the culture flask leaks upon the receipt of cells.
3 Any compliant on the cells, please take photos and contctat our technicians.