Resin fungi|354525 |BNCC

Essential Information Certificate Related Products

Hormoconis resinae

Subculture procedure	① Prepare 1-2 of the above plates; ② Open the safety cabinet, burn the top with an alcohol lamp, quickly drip sterile water to break it, and then use tweezers to crush it; ③ Take 0.5mL of sterile water and transfer it into a freeze-drying tube. After fully dissolving the bacterial powder, transfer it into two plates, each Agar plate containing about 200 μ L, and apply evenly; ④ Place the petri dish under the above cultivation conditions for cultivation, and once the bacterial strain grows, it can be used.
Growth conditions	25-28 ℃; 3-5 days; aerobic;
Storage conditions	2-8 ℃
Safety level	1
morphology	Migratory growth, producing a large number of spores, irregular edges, opaque, gray white on the front and gray white on the back, flat morphology, rough surface, dry texture, purity: pure
Sharing mode	Public welfare sharing

Hormoconis resinae

Storage conditions: 2~8 ℃

No. 354525

Product format: agar slant in 14mm test tube

Validity period: growing culture, in 30 days

Biosafety level: 1, handle in ultra-clear table or safety cabinet

Receiving notice: if any abnormality is found on the day of receipt, please contact the customer service within 24 hours. If it is overdue, it is deemed that the bacteria are well. The freeze dried culture shall be used up once and shall not be retained. The bacterial viability will resume after 1-2 generation of recovery and can be used normally. Handling instructions of agar slant and suspension liquid is enclosed. Please operate in strict accordance with this instruction, otherwise the replacement of bacteria are not be available in case of aberrant growth and loss of viability.

Growth conditions: 28°C, aerobic, integrated PDA, 5-7 days. Comprehensive PDA: Potato cooking liquid 1.0L, glucose 20.0g, KH2PO4 3.0g, MgSO4 7H2O 1.5g, trace amount of vitamin B1, agar 20.0g, pH 6.0±0.2. Sterilize at 121℃ for 15min. Potato cooking liquid: Weigh 200g peeled potato pieces, boil in boiling water for 30min, collect the filtrate and dilute to 1.0L.

Recovery steps:

(1)Prepare 1-2 pieces of PDA plates;

(2)Sterilize the surface of test tube for the agar slant, open it in the biosafety cabinet;

(3) Cut into the pieces with aseptic inoculation hoe and inoculation shovel (see attached page). the size of square pieces is 0.5 × 0.5cm2;

(4) Lay flat the small pieces to the center of the agar plate;

(5) Put the plates under the above culture conditions, and the strains can be used when they grow.

Recovery record: According to the recovery instructions, the results of the recovery are reported as follows:

Item	test results
viability	good viability,in 5 days plate colony is obvious
colony morphology: (above)	Small filamentous fungi have obvious colonies on the comprehensive PDA medium, dense and vigorous hyphae, white hyphae in the early stage, gray-white in the later stage, and light yellow on the back of the medium.
Conclusion	good viability, no abnormal colony morphology, qualified

Download certificate