Mycobacterium gordonae

Strain number:  360505

Batch number:220601

Biosafety  level: 2, handle in safety cabinet 

Provide form: Freeze-dried  beveled bacterial  liquid  plate

Receiving notice: if any abnormality is found on the day of receipt, please contact the customer service within 24 hours. If it is overdue, it is deemed that the bacteria are well. The freeze dried culture shall be used up once and shall not be retained. The bacterial viability will resume after 1-2 generation of recovery and can be used normally. The freeze-dried powder is stored at 2~8℃, and the validity period is 6 years; the slant surface is stored at 2~8℃, and the validity period is 1~3 months; the plate and bacterial liquid are stored at 4℃, and the validity period is 7 days. 2 years. Please operate in strict accordance with this instruction, otherwise the replacement of bacteria are not be available in case of aberrant growth and loss of viability.

Medium: 7H10 agar medium (English name: 7H10): ammonium sulfate 0.5g, potassium dihydrogen phosphate 1.5g, disodium hydrogen phosphate 1.5g, sodium citrate 0.4g, magnesium sulfate 0.025g, calcium chloride 0.5mg, zinc sulfate 0.001 g, copper sulfate 0.001g, sodium L-glutamate 0.5g, ferric ammonium citrate 0.04g, pyridoxine hydrochloride 0.001g, biotin 0.5mg, malachite green 0.25mg, agar 15.0g, and draw 5ml of glycerol, Add 900ml of distilled water, heat and stir to dissolve, boil for 1 minute, pH 6.4-6.8. Autoclave at 121°C for 10 minutes. When cooled to 50-55°C, add 100ml of filter-sterilized OADC additive, mix well, and pour into a plate or test tube.

Growth conditions: 37°C;3-5 days; aerobic

Recovery steps:

(1)Prepare a test tube containing 5-10mL of liquid culture medium and 2 plates;

(2) Open the ampoule in the biosafety cabinet, heat the tip of ampoule in a flame, quickly drop sterile water to creak it, then break it with forceps;

(3) Draw 0.5mL of liquid culture medium into a freeze dried ampoule, fully rehydrate and transfer the solution to the liquid test tube, mix evenly;

(4) Inoculate a plate with 0.2mL of suspension liquid, repeat the step to obtain two plates;

(5) Put all the liquid test tubes and plates under the above culture conditions for cultivation, and the strains can be used when they grow.

viability: good viability, 3-5 days with obvious bacterial layer on the plate; colony is typical on the streaked plate

Morphological characteristics: Colony diameter is 1-2mm, round, neat edges, opaque, golden yellow on the front, golden yellow on the reverse, raised in the middle, smooth surface, bright surface, easy to provoke, moist texture, positive acid-fast staining (red) , Bacillus, purity: pure

Quality inspection map:

Conclusion:good viability， no abnormal colony morphology, qualified